Thursday, 31 May 2012

HP Compaq Presario CQ56, CQ62, G56, G62 Laptop Screen Replacement


The HP G56 and G62 laptop screens are 15.6 inch in size when measured diagonally and come fully with LED back-lighting. In this blog tutorial you will learn how to disassemble the Hp G56 or G62, remove the screen and replace it with a working one. This guide can be used if the screen is cracked, black or with lines on it.


HP G56-130SA Laptop Screen
For specific screen types check the screens at the links below;

HP G56 Laptop Screen
HP G62 Laptop Screen
Compaq Presario CQ56 Laptop Screen
Compaq Presario CQ62 Laptop Screen
HP G56-130SA Laptop Screen
HP G56-105SA Laptop Screen
HP G56-106SA Laptop Screen
HP G56-107SA Laptop Screen
HP G56-108SA Laptop Screen


Find others at the Laptop Screen Online.

Remove The Hp G56 Battery





remove the HP laptop battery before starting the replacement. It is important to do this to avoid further damage of the laptop.





Hp G62 Screen Bezel




We will carry out this repair and replacement without having to remove the front bezel totally. This is the faster way to do this but it must be carried out carefully.

Place your fingers between the screen and the bezel and start pulling. Use the image on the left as a guide.







Inside the screen panel area you will find two screw on the to sides. Remove the two screws. You will need a precision screwdriver for this process.









Pull the screen and bezel slightly forward and start removing the side screws. Note that if you pull too hard the bezel may snap.









In the image on the right you will find how you can use an object to keep the screen bent slightly. Doing this will give you enough room to remove the screw on the lower side of the screen. This must be done carefully.





In the middle of the laptop at the hinges area you will find the screen cable. The trick is to free this cables so that they do not snap during the removal of the screen. The cable will be held in the plastic holder of the laptop in the hinges area. REMEMBER TO PUT THE CABLE BACK IN PLACE WHEN INSTALLING A NEW SCREEN.









Next is to take the screen out through the side of the laptop. REMEMBER TO HAVE A DROPPING. This means that the laptop should be place at the edge of the table while removing the screen. ALSO REMEMBER THAT THE CABLE IS STILL ATTACHED so do this carefully.




The next job will be to remove the screen display cable. Place the screen on the table and at this time you will be able to see the screen part number. The one in the image is made by Samsung and with part number LTN156AT09. There are other makes that can be used as a replacement including LP156WH2 made by LG, B156XW02 V.2 made by AUO, BT156GW01 V.4 made by INNOLUX or N156B6-L06 made by Chi Mei.









The connection is held down with a clear tape. Pull the clear tape upwards as shown in the image on the left.










Disconnect the cable from the screen.







After all this you would have successfully removed the broken screen from the HP laptop. To install a new one simply carry out the process in reverse.

HP G56 Screen Removal



Wednesday, 30 May 2012

Acer Aspire One D257, D260, Happy, PAV70 Netbook Laptop Screen Replacement


This blog replacement guide can be used to dismantle and repair of damaged screen on Acer Aspire One D257, D260, D260-A Happy, PAV70 netbooks. The Acer Aspire One D257, D260, Happy, PAV70, PAV80 laptop netbook monitors are 10.1 inches in size diagonally with resolution of 1366 x 768.

Acer Aspire One D260-A Broken Screen

It is best to have the right screen before starting this replacement. Below are links to some of them;


Acer Aspire One D257 Screen
Acer Aspire One D260 Screen
Acer Aspire One D260-A Screen
Acer Aspire One Happy Screen
Acer Aspire One Happy 2 Screen
Acer Aspire One PAV70 Screen





FIRST THING YOU MUST DO IS TO REMOVE THE NETBOOK BATTERY BEFORE STARTING ANY REPAIRS ON A LAPTOP.

Remove Screw Covers




Use the image on the left to locate the plastic screw covers on the 2 lower sides of the screen bezel and remove with the aid of a flat precision screwdriver.








Acer Aspire One D257 Screen Replacement





After removing the tiny plastic cover also remove the screws underneath. These are the only screws holding down the Acer Aspire One D257, D260 and Happy Series.







Acer Aspire One D260 Remove Screen Bezel





Place your fingers in the tiny opening between the screen and the bezel and start pulling on all sides till it comes off. The Acer Aspire One D257, D260, D260-A, Happy, PAV70 and PAV80 bezels are fragile and can snap it not done carefully.







Acer Aspire One Happy - Remove Plastic Bezel Completely


Remove screen internal screws




Using the image on the left as a guide, on the two sides there are screws holding the screen to the back cover. Remove these screws.















Then place the screen carefully on the keyboard. Note that if your laptop has come with a camera this is the best time to disconnect it.










One the back of the netbook screen you will find the display cable and screen part number. The Aspire One series come usually come with B101AW06 made by AUO or N101L6-L0D Rev C1 made by Chi Mei. The two mentioned screens are the most common ones.











To remove the display data cable first pull upwards the clear tape holding it down and the pull the connections apart.










At this time you would have successfully disassembled the netbook screen area. To install a new screen simply continue in reverse.

Acer Aspire One LCD Removed

Tuesday, 29 May 2012

Sony Vaio PCG 71911M, 71C11M, VPCEH, VPCEH1L8E, VPCEH1S0E Laptop Screen Replacement


In this blog tutorial I will show you how to dismantle and replace cracked or flickering screen on Sony Vaio PCG 71911M, 71C11M, VPCEH, VPCEH1L8E, VPCEH1S0E Laptop series. The Sony Vaio PCG 71911M, 71C11M, VPCEH, VPCEH1L8E, VPCEH1SOE Laptop series come solely with 15.5 HD LED LCD XBLACK widescreens with resolution of 1366 x 768.

Broken Sony Vaio VPCEH Laptop Screen


Before starting the repair make sure you get the right screen from the links below;







Usually to replace a laptop screen tools that are needed are precision screwdrivers and the LCD screen only.
This instruction should be followed carefully and can be used if the display monitor is cracked, dark, black or with coloured lines on it.










Always remove the laptop battery and only use it if you have to test the screen during the replacement.







Screen Cover Removal





On the four corners of the laptop you will find plastic covers. Remove them and this will reveal the screws holding the screen area of the laptop together.







Pull The Screen To Release Bezel

Place your fingers between the Sony Vaio screen and the bezel and start pulling slightly on all the sides until the bezel is pulled free from the laptop. This needs to be done carefully as shown in the images below.











Sony Vaio  bezels are very fragile and can easily snap so do this with care. You must not pull too hard.


Using the image below as a guide pull the screen forward slightly and remove all the side screws. Keep the screen aside as they are totally different from the rest of the screws in this repair.


Sony Vaio Side Screws


Placed face-down on the keyboard area to expose the back of the screen which consists of the screen display cable, connectors and screen part number. The part number for the Sony Vaio PCG 71911M, 71C11M, VPCEH, VPCEH1L8E, VPCEH1S0E Laptop notebook will have part number as below;

B156XW02 made by AU Optronics
LP156WH4, LP156WH2 made by LG Philips
LTN156AT02, LTN156AT05, LTN156AT09 or LTN156AT16 made by Samsung
N156B6-L06 made by Chi Mei or N156BGE-L21 made by Chimei Innolux

All the above screens are compatible.

Back of Sony Vaio PCG-71911M Screen

Carefully remove the yellow or clear tape, pull up the clear tape and carry out the data disconnection as below. 
This must be done with care as any mistake may cause a permanent damage to the cable or the connector.

Remove Clear Tape

Pulling apart Sony Display Cable Connection




The screen removal process is complete. To replace the screen you now need to carry out the 
instruction in a reverse order. 


Screen Removal is Complete







Only buy original laptop screens as regular screens may not give you same quality and screen brightness control.





Sony Vaio Screen Removal

Monday, 28 May 2012

Dell Inspiron M5030, M5010, N5030, N5010, 15R, Q15R, N7010 Laptop Screen Replacement


In this tutorial you will learn how to disassemble and replace a broken or cracked LCD screen on Dell Inspiron M5030, M5010, N5030, N5010, 15R, Q15R, N7010 Laptop Notebooks. The Dell Inspiron M5030, M5010, N5030, N5010, 15R, Q15R, N7010 Laptop come with 15.6 inch HD WLED display monitor panel.

Broken Dell M5030 Screen

Before starting the screen replacement make sure you have the right screen to install. Choose from the below links;

Dell Inspiron 15R Laptop Screen
Dell Inspiron Q15R Laptop Screen
Dell Inspiron N5110 Laptop Screen
Dell Inspiron N5030 Laptop Screen
Dell Inspiron M5010 Laptop screen
Dell Inspiron M5030 Laptop Screen
Dell Inspiron N7010 Laptop Screen

You can find others replacement screens at Laptop Screen Online.



Always Remove Laptop Battery




Always make sure the laptop battery is removed before starting the screen repair.











The Dell Inspiron M5030, M5010, N5030, N5010, 15R, Q15R, N7010 Laptop mostly will not come with any screws in the bezel. All that is needed to remove the bezel is to put your finger between the screen and the plastic bezel and pull carefully until it released. Do this on all sides of the laptop.










The bezel of the Dell Inspiron M5030, M5010, N5030, N5010, 15R, Q15R, N7010 notebook are very fragile and pulling too hard may snap it.








By successfully removing the bezel you the internal part of the screen is now accessible. At the top two sides of the screen remove the screws holding it to the back cover and keep them safely.











On the two bottom sides there will be 2 or 3 screws. Unscrew them to free the screen arms totally from the back cover.












At this point the screen can now be lowered to reveal the screen cables and LED connection. This area must be handled with care.











On the two sides of the screen remove all the screws holding the screen to the hinges arms and keep them safely.










Place the screen face-down and disconnect the Led cable. Note that sometimes this connection is held down by a clear tape. Raise and peel the clear tape with a flat screwdriver before disconnecting the cable.







The screen removal process is now complete. To install a new screen simply carry out the whole process backward (in reverse order).



Sunday, 27 May 2012

Samsung N110, N120, N130, N140, N150, N210, N220, N230, NP N310 Screen Replacement


Replacing the Samsung N110, N120, N130, N140, N150, N210, N220, N230, N310 laptop netbook screen yourself can save you a lot of money. The instruction outlined in this blog will show you how to dismantle, remove the screen and replace it with a new one.

The laptops come with 10.1 inch LED display when measured diagonally. The resolution are 1024 x 600 WSVGA.


Samsung N130 Nebook with cracked screen
TO START GET THE RIGHT SCREEN YOU NEED FIRST. Choose from the links below;

Samsung N110 Laptop Screen
Samsung N120 Laptop Screen
Samsung N130 Laptop Screen
Samsung N140 Laptop Screen
Samsung N145 Laptop Screen
Samsung N150 Laptop Screen
Samsung N210 Laptop Screen
Samsung N220 Laptop Screen
Samsung N230 Laptop Screen
Samsung N310 Laptop Screen


Use this instruction if the below has occurred

a. You dropped the netbook and cracked the screen
b. The netbook has coloured lines running vertically
c. The screen has gone dark with no backlight

Samsung N220 Battery






Always remove the battery of a laptop before starting any work on it.















One the four corners of the screen there are 4 plastic covers as sown in the image on the right. Remove the covers with a flat object.











Underneath these covers are the screws. Use a Precision screwdriver to remove them.












The next thing is to remove the plastic bezel. Place your finger between the screen and the bezel and pull on all sides until it comes off.











With the image on the left find all the screw holding the screen to the back cover and unscrew them carefully.











Disconnect the camera cable.











By placing the screen face-down gently you will be able to see the back of the panel and cable connections.









Remove the clear tape holding down the connection and pull it apart.








Sometime you will find hyphenated letters at the bottom label of the netbook. For example KA01UK, KA02UK, KA03UK, KA04UK, KA05UK etc. The numbers do not affect the screen type in the laptop as they all come with the same type or LCD. The Samsung NP series netbook usually comes with screen part numbers LTN101NT02 (Samsung Make), LTN101NT06 (Samsung Make), LP101WSA (LG Philips Make), N101L6-L02 (Made by Chi Mei), N101L6-L01 Rev C1 and C2, or B101AW03 (AU Optronics Make).









Remove all side screws.







The screen removal process is complete. Simply continue in reverse with a new screen to complete the installation.

Screen Removal Complete